![]() I used a fresh image (udoobuntu-udoo-qdl-desktop_2.1.4.img) and installed the webserver as described ( ). But now it seems that the server can't connect to the arduino due. Now I went back on using the udoo together with the repetier- server. I tried to run it with 115200 baud, but the amount of errors still remains. Are there any other tasks I can try to solve this issue?Ģ0:26:06.915 : Warning: Seems like we missed a ok, got a wait - continue sending.Ģ0:26:20.824 : Warning: Seems like we missed a ok, got a wait - continue sending.Ģ0:26:27.779 : Warning: Seems like we missed a ok, got a wait - continue sending.Ģ0:26:46.905 : Warning: Seems like we missed a ok, got a wait - continue sending.Ģ0:26:53.862 : Warning: Seems like we missed a ok, got a wait - continue sending.Ģ0:26:59.076 : Warning: Seems like we missed a ok, got a wait - continue sending.Ģ0:27:16.465 : Warning: Seems like we missed a ok, got a wait - continue sending.Ģ0:27:28.635 : Warning: Seems like we missed a ok, got a wait - continue sending.Ģ0:27:33.853 : Warning: Seems like we missed a ok, got a wait - continue sending.Ģ0:27:44.286 : Warning: Seems like we missed a ok, got a wait - continue sending.Ģ0:27:52.979 : Warning: Seems like we missed a ok, got a wait - continue sending.Īs you can see, the warnings and errors are very frequently. stl- file, which helped a bit, but not entirely. To counteract this phenomen, I lowered the solution of the. Due to the symptoms I suggest the problem is at the host side, repectively at Repetier- Host. ![]() EEPROM_MODE an other value, the new baud rate were set and I were able to communicate again.īut one problem, which I tried to solve by increasing the baud- rate, still occur.The Printer stumble sometimes. Thank you very much! -) after giving par. I can't explain, why do I get informations from the printer, and after a few seconds I have this communication error. ![]() Why do Ihave an error (how can I figure out the error's source?) and why do I have this communication error? The baud rates in the FW and on Repetier Host are the same (115200). ![]() What I don't understand are the Bold lines. I also searched at the internet for help, but I could not find any equal cases. I'm kind of new to the Repetier- FW (i used marlin until now), thereby I don't know a lot about those error messages.
0 Comments
Leave a Reply. |